This tool version is unpublished and cannot be run. If you would like to have this version staged, you can put a request through HUB Support.
You are here: resources › Tools › Roller Compactor › About
Roller Compactor
Calculate nip angle, normal and shear stresses for roller compactor using Johanson's model
Launch Tool
Archive Version 1.0.2
Published on 27 Jan 2014
Latest version: 1.2. All versions
This tool is closed source.
Category
Published on
Abstract
The impact of material properties and process parameters are determined using a continuum model. Normal stresses for roller compaction are calculated from Johanson's rolling theory. The boundary between the slip and nip regions is calculated using Johanson's criterion, i.e. gradients of stress in slip and nip regions are assumed to be equal at nip angle. Shear stresses are calculated from the normal stresses using the method of Schonert and Sander.
INPUT PARAMETERS:
Roll Gap / Roll Diameter,
Effective angle of friction,
Applied feed pressure,
Horizontal load ratio,
Compressibility.
OUTPUT:
Normal stress plot,
Shear stress plot,
Nip angle,
Slip region gradient plot,
Nip region gradient plot.
Credits
Model developed by A.J. Hlinak,
pharmaHUB tool developed by K. Kuriyan,
Pharmaceutical Technology and Education Center,
Discovery Park, Purdue Univeristy
References
Johanson, J. R. (1965) A rolling theory for granular solids. J Appl Mech, 32(4), 842-848.
Sommer, K., Hauser, G. (2003) Flow and compression properties of feed solids for roll-type presses and extrusion presses. Powder Technol, 130(1-3), 272-276.
Schonert, K., Sander, U. (2002) Shear stresses and material slip in high pressure roller mills. Powder Technol, 122(2-3), 136-144.
Cite this work
Researchers should cite this work as follows: